Wiring for Zero Delay Controller - For EDIERRE pushbutton panel

Special version for pushbutton panel EDIERRE with measurement Faston 6,3mm

Allows the connection of an EDIERRE Joystick to a ZERO Delay Usb controller

(usually used for Sanwa or other Joysticks)

Set contents - 1 piece Harness assembly for 1 Joystick

Flat cable with 5-PIN White connector to be connected to a ZERO DELAY controller of various brands, from cream to green ones.

Check from the pictures if your controller has the same connector.

The wires towards the micron of the Joystick are stretched for easier positioning:

- common thread in bridge between the various microns

- single wires to the various UP-DOWN-SX-DX commands

NOT INCLUDED ZERO DELAY CONTROLLER - If you need the controller complete with cables there is the appropriate product. HERE

NOT INCLUDED MICRON EDIERRE GROUP - It is delivered with the purchase of an Edierre Joystick